Disconnect the rear camera cable from the main harness.
Connect the V-Out cable into the rear-camera input on the main harness.
Plug the rear camera into any of the 1–4 CAM inputs on the MB100, and connect any additional cameras to the remaining CAM inputs.
The NIFR-INT Interior camera will require and ex
Important Notes
The MB100 must be unplugged before changing any toggle switch positions.
Switch 5 should always remain ON.
Toggle Switch Configuration
2-Channel (Left–Right View)
Switches 1–4 ON
2-Channel (Top–Bottom View)
Switches 2–4 ON, switch 1 OFF
3-Channel (Two on Top, One on Bottom)
Switches 1, 3, and 4 ON, switch 2 OFF
4-Channel View
- Switches 3 and 4 ON, switches 1 and 2 OFF
*NOTE* Inputs on MB100 are camera location specific. Channel 1 is left camera. Channel 2 is right camera. Channel 3 is rear camera. Channel 4 is Interior camera. Example, if you are only adding a rear and interior camera, set DIP switch 1 to OFF, then DIP switches 2,3 and 4 to ON, then use input 3 for rear and input 4 for interior. Inputs 1 and 2 will not produce any video in this mode.